DIMENSIONS
 |
Uses: Low voltage, high sensivity
Main applications: Electronic printed circuit. This pressure switch is more sensible than snap action models and can be calibrated at lower pressure values. Very small differential.
Membranes: EPDM, dia 22 mm. Silicone or NBR on request
Fluid: water or air
Fitting: Plastic
Pressure: positive
Housing: PA66, UL94 VO
Contact: single pole normally open, slow make.
Electrical rating:
- Silver contact: max 1A 250V
- Gold plated contact: max 100 mA, 24V
Action: momentary, close on pressure rise.
Set point calibration: factory calibrated and sealed, not field adjustable
Set point calibration limits: standard calibration 50mbar, other values are achievable from 20 to 400 mbar
Electrical connection: printed circuit terminal, dia 1 mm, 12.7mm spacing
Maximum pressure: 2 bars (29 PSI)
Ambient temperature limits: 0 to 85°C |
Available pressure inlet fittings 1
 |
 |
 |
 |
 |
 |
References ( with calibration at 50 mbar): |
Pressure inlet |
Silver contact |
Gold plated contact |
1/8’’ NPT |
ZE2X28F105000000 |
ZE2X28FG05000000 |
1/4’’BSPP |
ZE2X2QF105000000 |
ZE2X2QFG05000000 |
M10 x 1 |
ZE2X2MF105000000 |
ZE2X2MFG05000000 |
Snap in fitting, 2 grooves dia 7.8 |
ZE2X2TF105000000 |
ZE2X2TFG05000000 |
Snap in fitting, 1 groove dia 10 |
ZE2X2ZF105000000 |
ZE2X2ZFG05000000 |
Snap in fitting, 1 spout dia 6 mm |
ZE2X2AF105000000 |
ZE2X2AFG05000000 |
Other set point values: replace 050 in the product reference by the requested value in mbar
|