Applications
This electronic temperature controller withthe simplest and the most instinctive setting by end user was designed for easy incorporation inside cabinets with DIN rail mounting. It can be used by untrained operators.
It provides simple On Off actiontemperature control.
End user has access to set point and differential setting only.
Adjustment of maximum temperature can beset.
Main features
Dimensions: 86.9 × 58 × 52.5mm
Display: 3+1 digit LED. The fourth digit is used to display °C or °F.
Set point setting: in normal use, the display shows the measured temperature. Push “+” or “-” keys will display the setpoint value, and at that time it can be adjusted with “+” and “-” keys. No action during 5 seconds will register the new set point value and bring back display to measured value.
Temperature differential setting: in normal use, the display shows the measured temperature. Push “D” key will display the differential value, at that time it can be adjusted with “+” and “-” keys. Push “D” again or no action during 5 seconds will register the new differential value and bring back display to the measured value.
Action: On-Off
Temperature sensor: Pt100 (2 or 3 wires) orNTC 10Kohms @25°C, B= 3380 (2 wires).
Accuracy: +/ -1% of scale
Temperature adjustment ranges:
-30+120°C (-20+250°F), with 1° display
-30+200°C (-20+390°F), with 1° display
Power supply: 90 to 240V, 50Hz or 60Hz
Relay output: 16A 250V res., 100,000 cycles.Output Led displays relay position.
Maximum possible set point adjustment byuser: push “D” button more than 10 seconds, display shows the maximum temperature that can be set by the user. Then it is possible to adjust this value with “+” and “-“. Push again on “D” or do nothing during 5 seconds will register the maximum possible setting value and control will come back to the measured valued.
Ambient: -20+60°C, 10-90% RH
Power: <4W
Fail safe safety:
- If no power supply, relay output contact will open.
- If Pt100 sensor or NTC is broken or not connected properly, relay output contact will open and display will show “EEE”.
- If measured temperature is higher than allowed by the set range, display will show HHH.
- If measured temperature is lower than-30.0°C or -20.0°F, display will show LLL.
Electrical connections:
- Power input: neutral, phase, ground, with2.5mm² terminals.
- Power output: neutral, phase, ground,with 2.5mm² terminals for direct connection to the load.
- Temperature sensor: three 2.5mm² screw terminal.
.svg)
.svg)